Endress+Hauser FEC 12 - Table of Contents

Table of Contents
Short Instructions
Notes on Safety . . . . . . . . . . 2
1 Introduction . . . . . . . . . . 3
1.1 Application 3
1.2 Measuring System 3
1.3 Operating Principle 3
2 Installation . . . . . . . . . . . 4
2.1 Electrical Connection 4
2.2 Technical Data 5
3 Operating Elements . . . . . . . 6
3.1 FEC 12 Electronic Insert 6
3.2 HART Communicator DXR 275 7
3.3 HART Menu Structure 7
4 Calibrating for Level Measurement 8
4.1 Basic Calibration at the FEC 12
Electronic Insert 8
4.2 Basic Settings using the HART
Communicator DXR 275 11
4.3 Extended Calibration using the
HART Communicator 275 12
5 Entries for the Measuring Point . 14
5.1 Locking/Unlocking Parameters 14
5.2 Tag Number 14
6 Diagnosis and Troubleshooting . 15
6.1 Alarms 15
6.2 Simulation 15
6.3 Description of Fault Responses,
Error Messages 17
6.4 Replacing the FEC 12 Electronic Insert 17
6.5 Transmitting Basic Settings 17
6.6 Transmitting All Settings 18
Supplementary
documentation
In addition to these operating instructions, the following documentation is also
available on the use of the FEC 12 electronic insert:
• Technical Information TI 242F/00/e: Multicap Probes DC ... E
• Technical Information TI 243F/00/e: Multicap Probes DC ... A
• Technical Information TI 240F/00/e: Multicap Probes DC ... T
• Operating instructions for the HART handheld terminal DXR 275
Electronic insert FEC 12 (HART)
Endress+Hauser 1