Endress+Hauser HMX50 - Configuration; Configuring the Device

17
Endress+Hauser
HART Loop Converter HMX50
3.4 Configuration
Configuring the Device
Configure the device using the buttons on the front side. Use the
▴, ▾, ESC, and OK
buttons for navigation. The following chapters contain more detailed information about the
menus.
The navigation principle is shown using the following example:
Fault in the plant
Changing the device data changes the device function.
‣ Before entering new device data, make sure the plant is not endangered by changing the
device data.
Iout1
OK 
Assignment
  ESC
▾▴
Characteristic
OK 
4 - 20 NE 43
  ESC   ESC
▾▴
Start value

 ESC
▾▴
End value
  ESC
▾▴
CAUTION
BA00371FEN_1417.fm Page 17 Tuesday, August 15, 2017 4:08 PM