TMT180 Installation
Endress+Hauser 7
2.2 Delivery contents
The delivery contents of the temperature head transmitter are as follows:
• Temperature head transmitter
• Installation screws, installation springs and E-rings
• Operating instructions
!
Note!
Please take note of the head transmitter accessories in chapter 8 "Accessories".
2.3 Registered trademarks
•iTEMP
®
and ReadWin
®
2000
are registered trademarks of Endress+Hauser Wetzer GmbH + Co. KG, Nesselwang, Germany
3 Installation
3.1 Installation conditions
• When installing and operating the unit, please take note of the allowable ambient temperature
(see chapter 10 "Technical Data").
3.1.1 Dimensions
The head transmitter dimensions can be found in chapter 10 "Technical data".
3.1.2 Installation point
• Sensor connection head to DIN 43 729 Form B
• Field housing
3.1.3 Installation angle
There are no limits as to the angle of installation.
To Next Page
Loading...
