To Next PageTo Next Page
Why is my Endress+Hauser Radar measuring incorrectly?
If your Endress+Hauser Radar device is measuring incorrectly, it might be due to a parameter configuration error. Review the parameter configuration and correct any mistakes.
How to fix CDI communication error on Endress+Hauser Radar?
If CDI communication isn't working on your Endress+Hauser Radar, the COM port setting on your computer may be incorrect. Check the COM port setting and change it if necessary.
What to do if "Communication error" is indicated on the Endress+Hauser Radar display?
If you see a "Communication error" message on the display of your Endress+Hauser Radar when starting the device or connecting the display, it could be due to: * Electromagnetic interference. Check the grounding of the device. * A broken display cable or display plug. In this case, replace the display.
What to do if values on Endress+Hauser Radar display are invisible?
If the values on your Endress+Hauser Radar's display are invisible, here are a few things to check: * The contrast setting might be too weak or too strong. Try increasing the contrast by pressing the indicated buttons simultaneously or decreasing it in the same way. * The display cable plug might not be connected correctly; ensure it is properly connected. * The display itself might be defective, in which case you should replace it.
What to do if Endress+Hauser Radar device measures incorrectly?
If your Endress+Hauser Radar device is providing incorrect measurements, the cause could be a parameterization error. To solve this, check and adjust the parameterization of the device.
Why Endress+Hauser Radar device does not respond?
If your Endress+Hauser Radar device isn't responding, it could be due to a couple of reasons: * The supply voltage might not be correctly connected; ensure you connect the correct voltage. * The cables might not be making proper contact with the terminals; make sure there's good electrical contact between the cable and the terminal.
How to fix the wrong slope of the measured interface level in Endress+Hauser Measuring Instruments?
The wrong slope of the measured interface level is caused by the wrong dielectric constant (DC value). To correct this, enter the correct dielectric constant (DC value) of the upper medium.
General| Device Type | Guided radar level transmitter |
|---|---|
| Application | Level measurement for liquids and solids |
| Measuring Range | Up to 30 m |
| Process Temperature | -40 to 200 °C (-40 to 392 °F) |
| Process Pressure | -1 to +40 bar (-14.5 to +580 psi) |
| Output Signal | 4-20 mA HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Housing Material | Aluminum, Stainless steel |
| Probe Type | Rod or cable |
| Material | Stainless steel, PTFE |
| Protection Rating | IP66/IP67 |
| Approvals | ATEX, IECEx, FM, CSA |
| Power Supply | 10.5 to 36 V DC |
