Endress+Hauser Levelflex FMP51 - Configuration of the On-Site Display; Factory Settings of the On-Site Display for Level Measurements; Factory Settings of the On-Site Display for Interface Measurements; Adjustment of the On-Site Display

Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus Commissioning via operating menu
Endress+Hauser 103
11.7 Configuration of the on-site display
11.7.1 Factory settings of the on-site display for level measurements
Parameter Factory setting for devices with 1 current
output
Factory setting for devices with 2 current
outputs
Format display 1 value, max. size 1 value, max. size
Value 1 display Level linearized Level linearized
Value 2 display Distance Distance
Value 3 display Current output 1 Current output 1
Value 4 display None Current output 2
11.7.2 Factory settings of the on-site display for interface
measurements
Parameter Factory setting for devices with 1 current
output
Factory setting for devices with 2 current
outputs
Format display 1 value, max. size 1 value, max. size
Value 1 display Interface linearized Interface linearized
Value 2 display Level linearized Level linearized
Value 3 display Thickness upper layer Current output 1
Value 4 display Current output 1 Current output 2
11.7.3 Adjustment of the on-site display
The on-site display can be adjusted in the following menu:
Setup → Advanced setup → Display