Levelflex FMP56, FMP57 FOUNDATION Fieldbus Commissioning (block-based operation)
Endress+Hauser 53
8. Set the block mode to Auto using the Block Mode/MODE_BLK parameter, TARGET
element. For this purpose, the Resource Block must also be set to the Auto block mode.
11.1.5 Additional configuration
1. Link the function blocks and output blocks.
2. After specifying the active LAS, download all the data and parameters to the field
device.
11.2 Scaling of the measured value in an AI Block
If the type of linearisation L_TYPE = indirect has been selected in an AI block, the measured
value can be scaled within the block. The input range is defined by the XD_SCALE parameter
Through its EU_0 and EU_100 elements. This range is mapped linearly to the output ranged
defined by the OUT_SCALE parameter through its EU_0 and EU_100 elements.
0
1
0
1
EU_100
XD_SCALE OUT_SCALE
EU_0
EU_0
EU_100
OUT_VALUE
A0017338
16 Scaling of the measured value in an AI Block
• If you have selected the Direct mode for the L_TYPE parameter, you cannot change
the values and units for XD_SCALE and OUT_SCALE.
• The L_TYPE, XD_SCALE and OUT_SCALE parameters can only be changed in the OOS
block mode.
To Next Page
Loading...
