Endress+Hauser Levelflex FMP57 - Page 29

Levelflex FMP56, FMP57 FOUNDATION Fieldbus Mounting
Endress+Hauser 29
Nozzle mounting
£150 (6)
H
ø 150 (6)£
A0015122
Length H of the rigid part of the rope probe
Probe H
FMP56,  rope 4 mm (0.16 in) 94 mm (3.7 in)
FMP57,  rope 4 mm (0.16 in) 120 mm (4.7 in)
FMP57,  rope 6 mm (0.24 in) 135 mm (5.3 in)
• Permissible nozzle diameter: ≤ 150 mm (6 in).
For larger diameters the near range measuring capability may be reduced.
For nozzles ≥ DN300: →  31.
• Permissible nozzle height
2)
: ≤ 150 mm (6 in).
For a larger height the near range measuring capability may be reduced.
Larger nozzle heights may be possible in special cases (see section "Rod extension/
centering HMP40 for FMP57").
• The end of the nozzle should be flush with the tank ceiling in order to avoid ringing
effects.
With thermally insulated vessels the nozzle should also be insulated in order to
prevent condensate formation.
2) Larger nozzle heights on request