Endress+Hauser Liquistation CSF48 - System Integration; Integrating the Sampler in the System

Liquistation CSF48 System integration
Endress+Hauser 63
8 System integration
8.1 Integrating the sampler in the system
8.1.1 Web server
Versions without fieldbus: An activation code is required for the web server.
Connecting the web server
‣
Connect the communication cable of the computer to the Ethernet port of the BASE2
module.
Base2
Web Browser
A0039619
 64 Web server/Ethernet connection
Establishing the data connection
All versions with the exception of PROFINET:
To ensure that your device has a valid IP address, you must disable the DHCP parameter in the
Ethernet settings. (Menu/Setup/General settings/Extended setup/Ethernet/Settings)
You can assign the IP address manually in the same menu (for point-to-point connections).
All versions including PROFINET:
You will find the IP address and subnet mask of the device under: DIAG/System information/
Ethernet.
1. Start your PC.
2. First, configure a manual IP address in the network connection settings of the operating
system.
Example: Microsoft Windows 10
3. Open Network and Sharing Center.
 Apart from your standard network, you should see an additional Ethernet
connection (e.g. as an "unidentified network").
4. Select the link to this Ethernet connection.
5. In the pop-up window select the "Properties" button.