Endress+Hauser Liquistation CSF48 - Sampling with a Flow Assembly

Mounting Liquistation CSF48
28 Endress+Hauser
5.2.3 Connecting the compressed air and sample supply on version with sampling
assembly
3
1
2
6
5
4
7
A0016593
 18 Connection of compressed air and sample
supply
1 Sampling assembly
2 Sample line
3 Gland
4 Gland to distribution arm
5 Compressed air hose for external compressed
air supply
6 "Insert" compressed air line
7 "Retract" compressed air line
1. Connect the sampling assembly (item 1) to the sample line (item 2) and guide the
sample line into the gland (item 3). The sample line ends in the gland to the distribution
arm (item 4).
2. Connect the black compressed air lines from the sampler (item 6) to the connections on
the sampling assembly.
3. In the case of the Liquistation CSF48 version without an internal compressor, connect
the black compressed air hose (item 5) to the external compressed air supply.
5.3 Sampling with a flow assembly
The sample is extracted either directly from the flow assembly which is installed in the base or
from an external flow assembly.
The flow assembly is used for sampling in pressurized systems e.g.:
• Tanks positioned at a height
• Pressure piping
• Conveyance using external pumps