Endress+Hauser Liquistation CSF48 - Setting up the Device

Mounting Liquistation CSF48
24 Endress+Hauser
5.2 Setting up the device
5.2.1 Connecting the suction line at the side on version with pump
1. When setting up the device, take the installation conditions into account.
2. Route the suction line from the sampling point to the device.
3. Fit a hose adapter on the hose.
4. Secure the hose adapter with a worm drive hose clip.
5. Screw the suction line onto the device's hose connection.
5.2.2 Connecting the suction line from below on version with pump
If the suction line is connected from below, the suction line is routed upwards behind the rear
panel of the sample compartment.
1. Remove the rear panel of the dosing compartment and sample compartment
beforehand.
2. Remove the drain plug from the hose gland located at the back of the device base.
3. Guide the suction line upwards and through the opening towards the front, as
illustrated.