A0008938-EN
12 Structure of the special measuring cables
A Semi-conductor layer
sc Shield
For further information on the cables and junction boxes, please refer to the
"Accessories" section.
Field device measuring cable connection
Proceed as follows to connect a conductivity sensor to the field device:
1. Open the housing cover to access the terminal block in the connection compartment.
2. Break through the perforation for a cable gland, mount a cable gland and guide the
cable through this gland.
3. Connect the cable in accordance with the terminal assignment (see connection
compartment sticker).
4. Tighten the cable gland.
Panel-mounted device measuring cable connection
To Next Page
Loading...
