Need help?Do you have a question about the Endress+Hauser cerabar S and is the answer not in the manual?
General| Manufacturer | Endress+Hauser |
|---|---|
| Category | Transmitter |
| Type | Cerabar S |
| Measuring principle | Piezoresistive |
| Pressure type | Absolute, Gauge, Differential |
| Measuring range | Up to 400 bar |
| Ambient temperature | -40 to 85 °C |
| Output signal | 4 to 20 mA HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Process connection | Flanged, threaded, hygienic |
| Housing material | Aluminum |
| Sensor material | Ceramic |
| Protection class | IP66 |
| Material | Ceramic |
| Approvals | ATEX, IECEx, SIL, NEPSI, FM, CSA |
| Power Supply | 10.5 to 45 V DC |
| Accuracy | Up to ±0.075% of span |
Lists available documentation for Cerabar S and Deltabar S FOUNDATION Fieldbus devices.
Guidance on navigating the manual, finding function groups and parameter descriptions.
Visual map of function groups and their corresponding menu paths in the ToF Tool.
Instructions for configuring pressure, level, and flow measurements using FF program.
Details the block structure including Resource, Transducer, and Analog Input blocks.
Description of parameters within the Resource Block for device management.
Description of parameters for various Transducer blocks and Analog Input block.
Configuration steps for Pressure, Level, and Flow measurements using ToF Tool.
Detailed explanation of parameters accessible through the ToF Tool interface.
Lists device messages, their causes, and recommended corrective measures.
Diagrams illustrating the ToF Tool menu structure and parameter groups.
To Next Page