Endress+Hauser cerabar S - Appendix: ToF Tool Operating Menu Overview

Cerabar S/Deltabar S Appendix
Endress+Hauser 161
12 Appendix
12.1 Operating menu (ToF Tool)
!
Note!
• The entire menu of Endress+Hauser parameters is depicted on the following pages. Some
Endress+Hauser parameters correspond to FF standard parameters. All other FF parameters can
only be configured by means of an FF configuration program. → For this purpose, see Section 6
Description of parameters (FF configuration program").
• The menu has a different structure depending on the measuring mode selected. This means that
some function groups are only displayed for one measuring mode, e.g. the "LINEARISATION"
function group for the "Level" measuring mode.
• In addition, there are also parameters that are only displayed if other parameters are appropriately
configured. For example the Customer Unit P parameter is only displayed if the "User unit" option
was selected for the PRESS. ENG. UNIT parameter. These parameters are indicated with a "*".
• For a description of the parameters, please refer to chapter 10 "Description of parameters (ToF
Tool)". The exact dependency of individual parameters on one another is explained here.