Endress+Hauser cerabar S - Page 162

Appendix Cerabar S/Deltabar S
162 Endress+Hauser
P01-xMx7xxxx-19-xx-xx-xx-043
*
*
*
B B B
A
B
A
*
2)
1)
*
X
*
*
B
2)
1)
2)
1)
1) Cerabar S with gauge pressure sensors or Deltabar S
2) Cerabar S with absolut pressure sensor
Continuation,
see the following page
MEASURED VALUE
GROUP SELECTION
Pressure
Level
Flow
POS. ZERO ADJUST
MAX. FLOW
MAX PRESS. FLOW
POS. ZERO ADJUST
POS. INPUT VALUE
POS. ZERO ADJUST
POS. INPUT VALUE
EMPTY CALIB.
FULL CALIB.
POS. ZERO ADJUST
POS. INPUT VALUE
CALIB. OFFSET
DAMPING VALUE
POS. INPUT VALUE
DAMPING VALUE
DAMPING VALUE DAMPING VALUE
LEVEL MODE FLOW-MEAS. TYPE
CUSTOMER UNIT F
MAX. FLOW
CUST. UNIT FACT. F
MAX PRESS. FLOW
DAMPING VALUE
SETTINGS
OPERATING MENU
POSITION ADJUSTMENT BASIC SETUP
PRESS. ENG. UNIT
CUSTOMER UNIT P
CUST. UNIT FACT. P
Mass
p. cond.
MASS FLOW UNIT
Gas
norm cond.
Volume
p. cond.
NORM FLOW UNIT
Gas
std. cond.
STD. FLOW UNITUNIT FLOW
There are parameters that are only displayed if other parameters are
appropriately configured.
For example the CUSTOMER UNIT P parameter is only displayed
if the "User unit" option was selected for the PRESS. ENG. UNIT parameter.
These parameters are indicated with a "*".
MEASURING MODE
Pressure
Level
Flow
MEASURING MODE
Deltabar S only
Deltabar S
only