Endress+Hauser cerabar S - Display

Description of parameters (ToF Tool) Cerabar S/Deltabar S
136 Endress+Hauser
P01-xMx7xxxx-19-xx-xx-xx-039
Fig. 33: DISPLAY group
MEASURED VALUE
QUICK SETUP
DISPLAYSETTINGS
POSITION ADJUSTMENT
OPERATING MENU
TOTALIZER SETUP
DISPLAY CONTRAST
MENU DESCRIPTION
ALTERNATE DATA
LANGAUGE
MAIN DATA FORMAT
ToF Tool, Table 16: OPERATING MENU → DISPLAY
Parameter name Description
MENU DESCRIPTOR
Selection
Specify contents for the main line of the on-site display in the measuring mode.
→ See also Operating Instructions BA301P (Deltabar S) or BA302P (Cerabar S), Section
5.1 "On-site display".
Options:
• Main measured value (PV)
• Main measured value (%)
• Pressure
•Flow
• Level
• Tank content
•Temperature
• Error number
• Totalizer 1
• Totalizer 2
The selection depends on the measuring mode chosen.
Factory setting:
Main measured value (PV)
MAIN DATA FORMAT
Selection
Specifies the number of places after the decimal point for the value displayed in the main
line.
→ See also Operating Instructions BA301P (Deltabar S) or BA302P (Cerabar S), Section
5.1 "On-site display".
Options:
•Auto
•x.x
•x.xx
•x.xxx
• x.xxxx
• x.xxxxx
Factory setting:
Auto