Endress+Hauser cerabar S - PROCESS VALUES Pressure

Description of parameters (ToF Tool) Cerabar S/Deltabar S
142 Endress+Hauser
P01-xMx7xxxx-19-xx-xx-xx-041
Fig. 35: PROCESSINFO group
→ For the PROCESS VALUES function group, "Pressure" measuring mode, see Page 142, ToF Tool, table 21
→ For the PROCESS VALUES function group, "Level" measuring mode, see Page 143, ToF Tool, table 22
→ For the PROCESS VALUES function group, "Flow" measuring mode, see Page 144, ToF Tool, table 23
→ For the PEAK HOLD INDICATOR function group, see Page 144, ToF Tool, table 24
FlowPressure Level
MEAS. VAL. TREND
SENSOR PRESSURE
SENSOR TEMP.
TOTALIZER 1
TOTAL. 1 OVERFLOW
TOTALIZER 2
TOTALIZER 2
TOTAL. 2 OVERFLOW PCB MAX. TEMP.
PCB MIN. TEMP.
RESET PEAKHOLD
MAX. MEAS. TEMP.
MIN. MEAS. TEMP.
PCB COUNT: T > Tmax
PCB CONUT T < Tmin
COUNTER T < Tmin
COUNTER T > Tmax
COUNTER P < Pmin
MAX. MEAS. PRESS.
MIN. MEAS. PRESS
COUNTER P > PmaxMEASURED VALUE
MEAS. VAL. TREND
LEVL BEFORE LIN
TANK CONTENT
SENSOR PRSSURE
SENSOR TEMP.
PRESSURE
CORECTED PRESS.
MEASRED VALUE
PRESSURE
CORRECTED PRESS.
MEASURED VALUE
SENSOR DATAPROCESS VALUE
OPERATING MENU
MEASURED VALUE
QUICK SETUP
PROCESS INFOSETTINGS
POSITION ADJUSTMENT TOTALIZER SETUP
MEAS. VAL. TREND
SENSOR PRSSURE
SENSOR TEMP.
PRESSURE
CORECTED PRESS.
ToF Tool, Table 21: OPERATING MENU → PROCESSINFO → PROCESS VALUES "Pressure"
Parameter name Description
Prerequisite:
• MEASURING MODE = pressure
MEASURED VALUE
Display
Displays the measured value
In the "Pressure" measuring mode, this value corresponds to the PRESSURE parameter.
PRESSURE
Display
Displays the measured pressure after sensor recalibration, position adjustment and
damping. This value corresponds to the MEASURED VALUE parameter in the "Pressure"
measuring mode.
P01-xMD7xxxx-05-xx-xx-xx-000
P
PV
Sensor
Analog
Input
Block
Pressure
Level
Flow
PRESSURE
Damping
CORRECTED
PRESS.
Position
adjust-
ment
Sensor
trim
SENSOR
PRESSURE
Transducer Block