Endress+Hauser cerabar S - Page 141

Cerabar S/Deltabar S Description of parameters (ToF Tool)
Endress+Hauser 141
SENSOR MEAS.TYPE
Display
Displays the sensor type.
• Deltabar S = differential
• Cerabar S with gauge pressure sensors = relative
• Cerabar S with absolute pressure sensors = absolute
Pmin SENS. DAMAGE
Display
Displays the minimum permissible absolute pressure of the sensor (vacuum-proofing).
Pmax SENS. DAMAGE
Display
Displays the maximum permissible absolute pressure of the sensor (overpressure-
proofing).
MAT. MEMBRANE
Display
Displays the membrane material
Factory setting:
As per version in the order code
→ For Deltabar S, see Technical Information TI382P or for Cerabar S, see Technical
Information TI383P, "Ordering information" section.
FILLING FLUID
Display
Displays the filling fluid.
Tmin SENSOR
Display
Displays the lower nominal temperature limit of the sensor.
Tmax SENSOR
Display
Displays the upper nominal temperature limit of the sensor.
SENS H/WARE REV
Display
Displays the revision number of the sensor hardware.
e.g.: 01.00
ToF Tool, Table 20: OPERATING MENU → TRANSMITTER INFO → SENSOR DATA (all measuring modes)
Parameter name Description