Endress+Hauser cerabar S - Page 137

Cerabar S/Deltabar S Description of parameters (ToF Tool)
Endress+Hauser 137
ALTERNATE DATA
Selection
Switch on "Alternating display" mode.
In this display mode, the on-site display alternates between the following measured
values depending on the measuring mode selected.
– Pressure: main measured value (PV), main measured value (%), pressure and
temperature
– Level: main measured value (PV), main measured value (%), pressure, level, tank
content and temperature
– Flow: main measured value (PV), main measured value (%), pressure, flow,
temperature, totalizer 1 and totalizer 2
Options:
•Off
•On
Factory setting:
Off
LANGUAGE
Selection
Select the menu language for the on-site display.
!
Note!
• Select the menu language for the ToF Tool via the "Options" menu → "Settings" →
"Language" tab → "Tool language" field.
Options:
•Deutsch
• English
• Français
• Italiano
•Español
• Nederlands
Factory setting:
English
DISPLAY CONTRAST
Entry
Adjust contrast of on-site display.
You specify the contrast of the display with a number.
Input range:
4...13, 4: contrast weaker (brighter), 13: contrast stronger (darker).
Factory setting:
8
ToF Tool, Table 16: OPERATING MENU → DISPLAY
Parameter name Description