Endress+Hauser Nivotester FTL325P - Page 32

Commissioning Nivotester FTL325P, 3-channel
32 Endress+Hauser
8.2.15 CH2 + CH3 (Δs) + CH1, MAX safety mode without fault
signaling CH1
ye
ye
yeye ye
CH1
CH3
CH1
CH2
4 4 4 4 4 4 4
5 5 5 5 5 5 5
6 6 6 6 6 6 6
CH1
CH3CH2
CH2
CH3
D
s
gn
gngngngn
gn
1 1 1 1 1
1 1
ye ye
rd rd
ye ye
1 2
0 V
15
15 15 15 15
22 23 24 22 23 24
22 23 24 22 23 24
22 23 2422 23 24
22 23 24
26 27 28 26 27 28
26 27 28 26 27 28
26 27 2826 27 28
26 27 28
16
16 16 16 16
15
15
16
16
2
2
2
2
2
2
2
3
3
3
3
3
3
3
MODE 1
1 2
ON
MAXMAX
MAX
1 2
ON
A0039221
 30 Switching behavior and signaling
Δs, e. g. Pump control at one tank and additional overfill prevention (HH level)
• 1 sensor for overfill prevention (HH level) connected at input signal 1 (terminal 7 and
terminal 8)
• 1 sensor (H-level pump control) connected at input channel 2 (terminals 33 and 34)
• 1 sensor (L-level pump control) connected at input channel 3 (terminals 37 and 38)
Relay outputs of output channels 2 and 3 switch simultaneously→  30,  32 . This
ensures, for example, that a pump can be switched on at L level and switched off at H
level. D
Relay output 1 does not switch until the HH level at input channel 1 has been reached.
Fault signaling for input channel 1 is switched off.
Fault signaling for input channels 2 and 3 is switched on.
When using the Liquiphant FTL51B sensor with electronic insert FEL67, sensor (H level)
FEL67 must be set to MAX safety and sensor (L level) FEL67 must be set to MIN safety.