Endress+Hauser NRF81 - Page 160

Operating menu Tankside Monitor NRF81
160 Endress+Hauser
"V1 input selector" submenu
This submenu is only present for devices with a V1 communication interface.
Navigation  Setup → Advanced setup → Communication → V1 X1-4 → V1
input selector
Alarm 1 input source 
Navigation  Setup → Advanced setup → Communication → V1 X1-4 → V1 input selector
→ Alarm 1 input source
Description Determines which discrete value will be transmitted as V1 alarm 1 status.
Selection • None
• Alarm 1-4 any
• Alarm 1-4 HighHigh
• Alarm 1-4 High or HighHigh
• Alarm 1-4 High
• Alarm 1-4 Low
• Alarm 1-4 Low or LowLow
• Alarm 1-4 LowLow
Factory setting None
Additional information
Read access Operator
Write access Maintenance
Alarm 2 input source 
Navigation  Setup → Advanced setup → Communication → V1 X1-4 → V1 input selector
→ Alarm 2 input source
Description Determines which discrete value will be transmitted as V1 alarm 2 status.
Selection • None
• Alarm 1-4 any
• Alarm 1-4 HighHigh
• Alarm 1-4 High or HighHigh
• Alarm 1-4 High
• Alarm 1-4 Low
• Alarm 1-4 Low or LowLow
• Alarm 1-4 LowLow
Factory setting None
Additional information
Read access Operator
Write access Maintenance