Endress+Hauser NRF81 - Advanced Settings; Simulation; Protecting Settings from Unauthorized Access

Commissioning Tankside Monitor NRF81
82 Endress+Hauser
9.3 Advanced settings
For a more detailed configuration of the signal inputs, the tank calculations and the signal
outputs refer to the Advanced setup submenu (→  124).
9.4 Simulation
To check the correct configuration of the device and of the control system, it is possible to
simulate different situations (measured values, diagnostic messages etc.). See the
Simulation submenu (→  244) for details.
9.5 Protecting settings from unauthorized access
There are two possibilities to protect the settings from unauthorized access:
• By an access code (→  46)
This locks the access via the display and operating module.
• By the protection switch (→  47)
This locks the access to W&M-related parameters by any user interface (display and
operating module, FieldCare, other configuration tools).