Endress+Hauser NRF81 - Setup Menu: Device Configuration and Units

Tankside Monitor NRF81 Operating menu
Endress+Hauser 121
15.3 "Setup" menu
Navigation  Setup
Device tag 
Navigation  Setup → Device tag
Description Enter a unique name for the measuring point to identify the device quickly within the
plant.
Factory setting NRF8x
Additional information
Read access Operator
Write access Maintenance
Units preset 
Navigation  Setup → Units preset
Description Defines a set of units for length, pressure and temperature.
Selection • mm, bar, °C
• m, bar, °C
• mm, PSI, °C
• ft, PSI, °F
• ft-in-16, PSI, °F
• ft-in-8, PSI, °F
• Customer value
Factory setting mm, bar, °C
Additional information
Read access Operator
Write access Maintenance
If the Customer value option is selected, the units are defined in the following
parameters:
• Distance unit (→  229)
• Pressure unit (→  230)
• Temperature unit (→  230)
• Density unit (→  230)
In any other case these are read-only parameters used to indicate the respective unit.