Endress+Hauser NRF81 - Page 229

Tankside Monitor NRF81 Operating menu
Endress+Hauser 229
"System units" submenu
Navigation  Setup → Advanced setup → System units
Units preset 
Navigation  Setup → Advanced setup → System units → Units preset
Description Defines a set of units for length, pressure and temperature.
Selection • mm, bar, °C
• m, bar, °C
• mm, PSI, °C
• ft, PSI, °F
• ft-in-16, PSI, °F
• ft-in-8, PSI, °F
• Customer value
Factory setting mm, bar, °C
Additional information
Read access Operator
Write access Maintenance
If the Customer value option is selected, the units are defined in the following
parameters:
• Distance unit (→  229)
• Pressure unit (→  230)
• Temperature unit (→  230)
• Density unit (→  230)
In any other case these are read-only parameters used to indicate the respective unit.
Distance unit 
Navigation  Setup → Advanced setup → System units → Distance unit
Description Select distance unit.
Selection SI units
• m
• mm
• cm
US units
• ft
• in
• ft-in-16
• ft-in-8
Factory setting mm
Additional information
Read access Operator
Write access Maintenance (if Units preset (→  121) = Customer value)