Endress+Hauser NRF81 - Structure and Function of the Operating Menu

Operability Tankside Monitor NRF81
36 Endress+Hauser
7.2 Structure and function of the operating menu
Menu Submenu /
parameter
Meaning
Operation Level Shows the measured and calculated
level values.
Temperature Shows the measured and calculated
temperature values.
Density Shows the measured and calculated
density values.
Pressure Shows the measured and calculated
pressure values.
GP values Shows the general purpose values.
Setup Parameters 1 to N Standard commissioning parameters
Advanced setup Contains further parameters and
submenus:
• to adapt the device to special
measuring conditions.
• to process the measured value.
• to configure the signal output.
Diagnostics Diagnostic
parameters
Indicates:
• The latest diagnostic messages and
their timestamps.
• The operating time (overall time and
time since last restart).
• The time according to the real-time
clock.
Diagnostic list Contains up to 5 currently active error
messages.
Device information Contains information needed to
identify the device.
Simulation Used to simulate measured values or
output values.
Expert
1)
Contains all parameters of the device (including
those which are already contained in one of the
other menus). This menu is organized
according to the function blocks of the device.
The parameter of the Expert menu are
described in:
GP01083G (NRF81)
System Contains all general device parameters
which do not affect the measurement
or the communication interface.
Input/output Contains submenus to configure the
analog and discrete I/O modules and
connected HART devices.
Communication Contains all parameters needed to
configure the digital communication
interface.
Application Contains submenus to configure
• the tank gauging application
• the tank calculations
• the alarms.
Tank values Shows measured and calculated tank
values
Diagnostics Contains all parameters needed to
detect and analyze operational errors.
1) On entering the "Expert" menu, an access code is always requested. If a customer specific access code has
not been defined, "0000" has to be entered.