Proline Prosonic Flow 91W Hardware and software settings
Endress+Hauser
21
A0011376
Fig. 21: Connecting the connecting cable
This completes the mounting process. The sensors can now be connected to the transmitter via
the connecting cables ä 23.
2.8 Post-installation check
• Are cables or the device damaged (visual inspection)?
• Does the device correspond to specifications at the measuring point, including process
temperature and pressure, ambient temperature, minimum fluid conductivity,
measuring range, etc.?
• Are the measuring point number and labeling correct (visual inspection)?
• Have the inlet and outlet runs been observed?
• Is the measuring device protected against mois
ture and direct sunlight?
3 Hardware and software settings
Diverse hardware and software settings are possible or necessary (e.g. device address
configuration) for measuring devices with PROFIBUS DP or FOUNDATION Fieldbus type of
communication. For a description of the possible settings and the exact procedure that applies
for the different types of communication, see the associated Operating Instructions on the CD.
To Next Page
Loading...
