Need help?Do you have a question about the Endress+Hauser prosonic flow 92 and is the answer not in the manual?
General| Device Type | Ultrasonic flowmeter |
|---|---|
| Process Pressure | Up to 40 bar |
| Communication Protocols | HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Housing Material | Aluminum, stainless steel |
| Measuring Principle | Ultrasonic Transit-Time Difference |
| Accuracy | ±0.5% of reading |
| Output Signal | 4 to 20 mA, pulse |
| Power Supply | 24 V DC |
| Ingress Protection | IP66/67 |
| Protection Rating | NEMA 4X |
| Repeatability | ±0.15% of reading ±0.005 m/s |
| Process Temperature | -40 to 200 °C |
Essential safety information and warnings for safe operation.
Requirements for safe installation, commissioning, and operation by qualified personnel.
Guides on how to physically install the flow measuring sensors onto the pipe.
Explains traverse configurations for clamp-on sensors and sensor type recommendations.
Detailed steps for installing and securing tensioning bands for sensors on large diameter pipes.
Guides on navigating and using the device's function matrix for configuration.
Explains that the Site Setup menu aids systematic configuration of functions and sensor installation.
Provides a checklist to identify fault causes and appropriate remedial measures.
Lists common error messages, their descriptions, and recommended remedies or spare parts.
Outlines the structure of the function matrix with groups and function groups.
Details functions like Oper. Mode, Setup, Graph. Display, Delete Log, Start Log, Log Name, Volume Flow.
Details functions like Set Date/Time, Baud Rate, Parity, Stop Bits, System Units.
Details functions like Actual Value, Input Range, Current Adjust.
To Next Page
