Prosonic Flow 92 5Operation
Endress+Hauser 39
5.3.1 General notes
The Site Setup menu (see Page 42) is adequate for commissioning with the necessary
standard settings. Complex measurement tasks on the other hand necessitate addi-
tional functions that you can configure as necessary and customise to suit your process
conditions. The function matrix, therefore, comprises a multiplicity of additional func-
tions which, for the sake of clarity, are arranged in groups, function groups and func-
tions.
Comply with the following instructions when configuring functions :
• You select functions as described on Page 38.
!
Note!
• The transmitter continues to measure while data entry is in progress, i.e. the current
measured values are output via the signal outputs in the normal way.
• If the power supply fails, all preset and parameterised values remain safely stored in
a memory backup powered by a lithium battery.
"
Caution!
All functions are described in detail, including the function matrix itself, in the “Descrip-
tion of device functions” appendix which is a part of these Operating Instructions.
5.4 Error messages
Errors which occur during commissioning or measuring operation are displayed imme-
diately. If two or more system or process errors occur, the error with the highest priority
is always the one shown on the display. For “Error messages” see Page 50.
To Next Page
Loading...
