5 Operation Prosonic Flow 92
38 Endress+Hauser
5.3 Brief operating instructions for the function
matrix
!
Note!
• See the general notes on Page 39.
• Descriptions of device functions
→ see Page 63
1. Power on
→ start-up approx. 10 sec. → entering function matrix, group
MEASUREMENT
2. Select a group (e.g. SITE SETUP)
3. Select a function group (e.g. SITE DATA)
4. Select a function (e.g. PIPE MATERIAL)
Change parameter / enter numerical values:
Select or enter parameters, numerical values using cursor control, U, V, W, W, ENT
and ESC.
5. Exit the function matrix:
Power off
Fig. 31: Selecting functions and configuring parameters (function matrix)
1 Entering the function matrix
2 Selecting a group
3 Selecting a function group
4 Selecting a function level (1...3 sub-levels are possible depending on the function group)
!
Note!
To go from one group to the next, you must first activate the group navigator. To do so,
use the U key and then use the V and W keys to move up or down.
F06-92xxxxxx-13-xx-xx-xx-000
To Next Page
Loading...
