9 Trouble-shooting Prosonic Flow 92
54 Endress+Hauser
9.7 Replacement of built-in battery
The built-in battery is a special Ni-Cd type of battery. This battery can be charged
approx. 500 times in its service life. Proceed as follows to replace a used battery:
1. Remove the two Phillips screws (1) in the lower housing cover.
2. Remove the housing cover (2).
3. Disconnect the battery plug (3).
4. Carefully remove the battery (4) from the transmitter and replace it with a new one.
!
Note!
You can order spare parts directly from your E+H service organisation by providing the
serial number printed on the nameplates (see Page 9).
5. Installation is the reverse of the removal procedure.
Fig. 38: Replacing the built-in battery.
9.8 Software history
!
Note!
Usually, an upload or download between the different software versions is only possible
at Endress+Hauser. Please contact your nearest E+H service organisation.
Software version /
date
Changes to software Documentation
changes/additions
Amplifier
V 1.00.00 / 06.2002 Original software.
−
V 1.01.00 / 01.2004 Software expansion:
New functionalities
• Expansion
• Selection table fluids
F06-92xxxxxx-17-00-06-xx-000
To Next Page
Loading...
