3.4 Rotating the electronics housing
The electronics housing of Prowirl 77 can be rotated in 90° steps on the pipe stand.
This is carried out as follows:
➀ Remove the securing screw at the pipe stand (minimum one turn).
➁ Pull out the electronics housing to the mechanical stop and then
rotate it to the position required (in 90° steps). Push the housing back
into the housing support.
➂ Fasten the securing screw.
ba037y28
➁
➁
➁
➀
➂
Fig. 10
Rotating the electronics housing
3 Mounting and Installation Prowirl 77 PROFIBUS-PA
14 Endress+Hauser
To Next Page
Loading...
