Battery Charger RX
User's Manual
5. Operation
PRELIMINARY CONTROLS
• Inspect the charger completey for loose screws, electrical connections or other damages;
• Check that all the ventilation slots are not obstructed to assure proper air flow;
• Make sure that the charger is installed as instructed in this manual and in accordance with
any applicable national or local norm.
• Set the main switch to position “0”;
• Connect the charger to the battery;
When the battery is correctly connected, the LEDs on the control panel start to flash alternately.
LED CONTROL PANEL
OWM-040906-RX Version: 02-AB Page 11 of 25
To Next Page
Loading...
