Battery Charger RX
User's Manual
START OF THE CHARGE
The charger can be turned on only when the battery is correctly connected.
CHARGE OPERATIONS
When the battery is connected, the charger turns on automatically in 5 seconds and the LED
“CHARGE ON” starts to flash.
If the main supply is not present, all the control LEDs (except the “BATTERY CONNECTION”
LED) starts to flash alternately.
START OF THE CHARGE
When the charge is started, check that the LED “CHARGE ON” is flashing at frequency of about
1 second. This control is useful to be sure that the electronic control is working correctly.
Energic Plus RX chargers are programmed to do a complete cycle of charge, however it’s
recommended to survey the operations when the battery must remain connected to the charger
for more than 12 hours (example: week-ends)
OWM-040906-RX Version: 02-AB Page 19 of 25
WARNING !
When the charge is started, check that the LED “CHARGE ON” is flashing at
frequency of about 1 second. This control is useful to be sure that the electronic
control is working correctly.
To Next Page
Loading...
