Need help?Do you have a question about the ENERMAX LIQMAX III and is the answer not in the manual?
General| Type | Liquid CPU Cooler |
|---|---|
| Radiator Size | 240mm |
| Pump Speed | 3100 RPM |
| Block Material | Copper |
| Radiator Material | Aluminum |
| Fan Size | 120mm |
| Bearing Type | Twister Bearing |
| Connector | 4-Pin PWM |
| Tube Length | 400mm |
| Warranty | 2 years |
| Fan Speed | 500 RPM |
| Compatibility | AMD AM4/AM3+/AM3/AM2+/AM2/FM2+/FM2/FM1 |
| Fan Airflow | 22.5 - 72.1 CFM |
Attach the fan and radiator to the chassis.
Install the Intel clip to the pump.
Insert position screws into back plate for LGA1200/115X/1366.
Insert position screws into back plate for LGA1700.
Install the Intel back plate onto the motherboard with stand-offs.
Tighten the Intel LGA2011/2011-3/2066 screw to the motherboard.
Apply thermal grease evenly on the CPU surface.
Remove the protect film from the cold-plate.
Place the pump on the CPU and tighten spring screws.
Connect the pump power connector to the motherboard.
Connect the fan connector to the motherboard.
Attach the fan and radiator to the chassis.
Install the AMD clip to the pump.
Remove original screws and place the back plate back into position.
Tighten the AMD screw to the AMD stock back plate.
Apply thermal grease evenly on the CPU surface.
Remove the protect film from the cold-plate.
Place the pump on the CPU and tighten spring screws.
Connect the pump power connector to the motherboard.
Connect the fan connector to the motherboard.
Connect the sync cable to a supported motherboard with ARGB header.
Control and cycle through lighting effects using M and arrow buttons.
Adjust the speed of lighting effects using arrow buttons.
Adjust the overall brightness of RGB lighting using arrow buttons.
Activate automatic color cycling modes and set specific colors.
To Next Page