EnerSys PowerSafe VM Series - Material Safety Data Sheet (Msds); SECTION I - Product and Manufacturer Identity; SECTION II - Ingredients Hazardous Components; SECTION III - Physical;Chemical Characteristics

INFORMATION ONLY - Please read Section IX
SECTION I - Product and Manufacturer Identity
Product Identity: Revision Date: March 2001
Sealed Lead Battery
PowerSafe
®
VM
Telephone Number:
(China) +86 755 2689 3639
(Europe) +32(0)2 247 94 47
(US) 610 208 1991
SECTION II - Ingredients
Hazardous Components CAS # OSHA PEL-TWA % (By weight)
Lead 7439-92-1 0.05 mg/m
3
45-60 %
Sulphuric Acid Electrolyte 7664-93-9 1.0 mg/m
3
15-20 %
Non-hazardous Materials N/A N/A 5-10 %
Lead dioxide 1309-60-0 0.05 mg/m
3
15-25 %
SECTION III - Physical/Chemical Characteristics
Boiling Point - N/A Specific Gravity (H
2
O=1) – NA
Vapor Pressure (mm Hg.) - N/A Melting Point - N/A
Solubility in Water - N/A Appearance & Color - N/A
SECTION IV - Fire & Explosion Hazard Data
Flash Point (Method Used): N/A Flammable Limits: N/A LEL: N/A UEL: N/A
Extinguishing Media: Multipurpose Dry chemical, CO
2
or Water spray.
Special Fire Fighting Procedures: Cool Battery exterior to prevent rupture. Acid mists and vapors in a fire are toxic and
corrosive.
Unusual Fire and Explosion Hazards: Hydrogen gas may be produced and may explode if ignited. Remove all sources of
ignition.
SECTION V- Reactivity Data
Conditions to Avoid: Avoid short circuit. Avoid over-charging. Use only approved charging methods.
Do not charge in gas tight containers. Avoid puncturing battery case.
MATERIAL SAFETY DATA SHEET (MSDS)
10