13Installation instructions for professionals
Setup wizard needs to be run in only one of the
panels. Switch the power on in the other panel
once you have congured the settings. The panel
retrieves the information from the motherboard.
NOTE
the panel can start. Panel shows that it is trying to connect
to the network. Press Re-connect the radio > Reset. The
control panel connects itself to the wall mount.
Connecting the indoor temperature
sensor to the wall mount (extra)
An indoor temperature sensor must be connected to the
ventilation unit, if the ventilation unit is to be used for
controlling indoor temperature. The indoor temperature
sensor is connected to the circuit board behind the wall
mount. If two wall mounts with an indoor temperature
sensor are installed, sensor TE20 is connected to wall
mount 1 and sensor TE21 to wall mount 2.
To Next Page
Loading...
