enervent Svea eAir - Product Information According to Eu Kommission Regulation (Eu) N:o 1253;2014 Ja 1254;2014

47Installation instructions for professionals
Enervent Svea
PRODUCT INFORMATION ACCORDING TO
EU COMMISSION REGULATION NO 1253/2014 AND 1254/2014
Supplier’s name or trade mark Enervent
Supplier’s model identier Svea
Specic energy consumption (sec) in kWh/(m
2
.A)
• Cold climate
• Average climate
• Warm climate
-76,8
-37,3
-14,6
Declared typology in accordance with article 2 of this regulation RVU / BVU
Type of drive installed or intended to be installed Multi-speed drive
Type of heat recovery system Regenerative
Thermal eciency of heat recovery 84,8
Maximum ow rate in m
3
/h 619
Electric power input of the fan drive, including any motor control equip-
ment, at maximum ow rate (W)
298
Sound power level (L
WA
), rounded to the nearest integer 48
Reference ow rate in m
3
/s 0,12
Reference pressure dierence in Pa 50
SPI in W/(m
3
/h) 0,31
Control factor and control typology in accordance with the relevant
denitions and classication in annex VIII, table 1
0,65
Declared maximum internal and external leakage rates (%) for bidirec-
tional ventilation units
<4% / <0,8%
Position and description of visual lter warning for rvus intended for use
with lters, including text pointing out the importance of regular lter
changes for performance and energy eciency of the unit
Filter warning on control
panel. Instructions in user
manual.
Internet address for disassembly instructions as referred to in point 3
https://doc.enervent.com/out/
out.ViewFolder.php?folderid=957
The annual electricity consumption (AEC) (in kWh electricity/a) 162
The annual heating saved (AHS) (in kWh primary energy/a) for each type
of climate
• Cold climate
• Average climate
• Warm climate
8084
4132
1869
A
The information on the energy label for this product has been dened with local demand control. Local demand control means that the ventilation unit continuously regulates the fan
speed(s) and ow rates based on more than one sensor. Please remember to connect all local sensors (some sold as extra equipment) in order to achieve the declared energy class.