ENFORCER E-922CPQ User Manual

ENFORCER Voice Dialer
10 SECO-LARM U.S.A., Inc.
Programming the Voice Dialer (Continued):
Making a Test Call
The dialer can make a test call to ensure that the numbers have been set up correctly. During the
call, the speaker allows you to monitor the call's progress. To place a test call, in setup mode:
1. Press the UP or DOWN button until you see "08 Test
Number" on the display, or press 08 on the keypad.
2. Press the ENTER button. You will see the first of your
programmed numbers on the display.
3. Press the UP and DOWN buttons to select the number you want to test dial.
4. Press the ENTER button to select and start the process. Listen in as it completes the call.
5. To interrupt the call, press the ESC button and press the UP and DOWN buttons to select
another number you want to test dial.
6. When finished, press the ESC button to return to the settings menu to program other functions.
7. Press the ESC button again to exit the setup mode.
The dialer is always active when powered. If connected to a security system, it will be ready when
the system is armed. In stand-alone mode, it can be disarmed by turning off power to the dialer.
Stopping Dialing with the Dialer Keypad
The dialer has no entry delay, so if it is installed in stand-alone mode, when you open the door
(assuming your door has a contact installed) or an input is accidentally triggered when you are at
the dialer location, it will immediately start dialing. You can stop its dialing and return it to standby
mode by pressing the ESC button on the dialer, typing your 4-digit PIN, and pressing ENTER.
Remote Control by Telephone
The system can be remotely controlled and monitored through any touch-tone (DTMF) phone,
including mobile phones.
REMOTE CONTROL WHEN THE ALARM IS ACTIVATED
When an alarm has been activated the voice dialer dials the pre-programmed alarm numbers. The
receiver will hear the pre-recorded message and may press one of the following function codes
within 10 seconds after the message ends to control the system remotely and a second code in 10
seconds for another function. If there is no response within 20 seconds, the dialer will hang up.
Function
Code
Set dialer to play messages only once
1
Set dialer to play messages twice
*
2
Repeat the message
3
Start listening in for 30 seconds, press code again to continue
listening
4
Stop the dialing process
and return the dialer to standby
0
*There will be a 10-second pause after or between each message to allow time
to enter a function code.
Operating the Voice Dialer:
Menu(1-12)
08 Test Number
Test Number
1:5555551212

ENFORCER E-922CPQ Specifications

General

Brand	ENFORCER
Model	E-922CPQ
Category	Intercom System
Language	English