ENFORCER E-922CPQ - Features and Components; Key Features Overview; Included Parts List

ENFORCER Voice Dialer
2 SECO-LARM U.S.A., Inc.
1x
Voice dialer unit
2x
Wall mount sc
rews
2x
Plastic wall anchors
1x
User manual
Parts List:
Features:
Table of Contents:
• Trigger-activated dialer with user-recorded 18-second alarm message
• The last 6 seconds of the alarm message is individually customizable for each input
• 3 Trigger inputs and 1 inhibit input, each programmable high (input >3.5V) or low (input <1V)
• 1 Auxiliary relay output, NO/NC programmable for 1~255 seconds
• Works as a stand-alone unit or connected to a security system
• LCD display indicates status, either "ready" or "alarm" showing which input and number dialed
• Listen in, stop the dialing process, and/or turn the auxiliary output on or off during dialer call out
• Call in at any time to listen in to room and/or turn the auxiliary output on or off
• 6 Programmable alarm telephone numbers (up to 14 digits each)
• Programmable auto-dialing to call each number three times or call a single number
• Built-in flash memory to protect against system data loss in case of power failure
• Tone or pulse dialing
• Terminal blocks for all external connections
• Wall-mountable
Table of Contents .......................................... 2
Features ........................................................ 2
Parts List ........................................................ 2
Specifications ................................................ 3
Sample Applications and Wiring Diagrams ... 3
Overview ........................................................ 4
Installation ..................................................... 4
Programming the Voice Dialer .................. 5~10
Entering Setup Mode ................................. 5
Setting and Changing the PIN ................... 5
Setting Alarm Phone Numbers .................. 5
Deleting a Stored Phone Number .............. 6
Recording Alarm Messages ...................... 6
Setting the Auto-Dial Mode ........................ 7
Setting the Trigger Level ........................... 7
Setting the Trigger Mode ............................ 8
Setting the Dialer "Beep" Volume ............... 8
Setting the Number of Rings for Remote
Access ...................................................... 9
Setting the Auxiliary Output Relay Time ..... 9
Setting the Number of Times the Alarm
Message Plays ......................................... 9
Making a Test Call .................................... 10
Operating the Voice Dialer ...................... 10~13
Stopping Dialing with the Dialer Keypad ... 10
Remote Control by Telephone ............ 10~11
Viewing the Last Event ............................. 11
Resetting the Dialer .................................. 11
Troubleshooting ............................................ 11
Notices, Warnings, and Warranty ................. 12