ENGLISH
37
Network
Off
No Ethernet connection
ON - Amber
Connected to the network
Transmitting/Receiving data
Network
LED A- Off
Complete initialization
LED A- Amber
Initializing
LED B- Blue
Connected to AC power supply
LED B – Off
No power is supplied to the device.
Hardware Reset:
In the event that your ATV freezes operation, you can press the “pinhole reset” button,
located on the back the device, by using a sharp object such as a toothpick.
MOTION REMOTE
1. Navigation Key
2. Mute
3. Home
4. VOL+
5. VOL-
6. Exit
7. Noti cation
8. Menu
9. OK
10. Zoom In
11. Zoom Out
Notes:
Press Navigation key to active or lock remote control.
If you can’t use remote control any more, please try to
check codes:
Press” mute + Zoom Out” buttons together for 3 se-
conds, LED will quickly fl ash, then slowly fl ash for three
times within 15 seconds, this means successfully done..
If there is no any LED light on the remote control, it
means there is no power, please connect micro USB
cable to charge up the battery, and the left red LED will
sparkle while charging.
Press Navigation key to active or lock remote control.
If you can’t use remote control any more, please try to
Press” mute + Zoom Out” buttons together for 3 se-
conds, LED will quickly fl ash, then slowly fl ash for three
times within 15 seconds, this means successfully done..
If there is no any LED light on the remote control, it
means there is no power, please connect micro USB
cable to charge up the battery, and the left red LED will
1 2
3
6
7
4
5
8
9
11
10
To Next Page
Loading...
