■ How to Install the Refrigerator.
(1) Your shockproof fridge is best installed on a solid surface.
(2) Be sure your fridge is not placed near a gas stove, heater or other
heat-generating appliances.
(3) Adequate ventilation and suitable distance from each wall (at least 150mm or more)
is necessary for the maximum cooling efficiency and minimum electric current consumption for
"free standing use"( see Fig.1 shown below).
(4) Avoid installing your fridge close to kitchen sink or faucet.
(5) If you use the fridge under the counter or in the fixing box, please note the
following air ventilation conditions.
① Make vent opening both under fridge or bottom and above fridge top cover.
② Vent opening size must be larger than 160㎠ for each opening ( the more air circulation over the
condenser, the more efficiently fridge will operate).
Failure to provide the necessary venting will result in poor refrigeration, continuous compressor
operation, accelerated battery discharge and sometimes shorten the life of fridge.
Top Cover
Minimum Opening
Wall or Box Case
At least 150mm
From Each Wall
Floor or Box Bottom
Minimum Opening
To Next Page
Loading...
