66
Management VLAN (Access Point / Repeater mode)
Profile Isolation Restricted client to communicate with different VID by selecting the radio button.
VLAN ID Specify the VLAN tag for each profile.
Management VLAN ID If your network includes VLANs, you can specify a VLAN ID for packets pass through the Access
Point with a tag. Otherwise, select No VLAN tag.
Accept / Cancel Click Accept to confirm the changes or Cancel to cancel and return previous settings.
Note:
1. If you reconfigure the Management VLAN ID, you may lose your connection to the ECB600. Verify that the DHCP server supports the
reconfigured VLAN ID and then reconnect to the ECB600 using the new IP address.
2. Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see section 5.1).
To Next Page
Loading...
