Name: EnGenius ENH202
Brand: EnGenius
Rating: 5 (1 reviews)

Questions and Answers:

Melissa MorganJul 26, 2025

How to reset EnGenius Wireless Access Point ENH202?

L
Lance ZimmermanJul 26, 2025
There are two ways to reset the ENH202 to its factory default configuration: a hardware method and a software method. For the hardware method, press the reset button behind the hole of the PoE injector for 10 seconds, or open the cover on the bottom panel of the ENH202 and find the Reset button (see section 2.1). Using a flat object such as a pencil, press the Reset button for approximately 10 seconds and then stop pressing. For the software method, click Restore to Factory Default in the Management menu.

EnGenius ENH202 Specifications

General

5 GHz	No
Modulation	16-QAM, 64-QAM, BPSK, QPSK
Frequency band	2.4 GHz
Operating modes	Access Point (AP), Client Bridge, Client Router, WDS
Channel bandwidth	40 MHz
Channels quantity	11 channels
Transmitting power	15 dBmW
Networking standards	IEEE 802.11b, IEEE 802.11e, IEEE 802.11g, IEEE 802.11n, IEEE 802.1x, IEEE 802.3, IEEE 802.3u
Virtual LAN features	Tagged VLAN
Spread spectrum method	DSSS
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Quality of Service (QoS) support	Yes
Antenna features	Integrated antenna
Antennas quantity	2
Antenna gain level (max)	10 dBi
Placement	Wall
Certification	FCC, CE, IC
Product color	White
International Protection (IP) code	IP65
Networking features	Fast Ethernet
Vertical beam width	21 °
Horizontal beam width	70 °
USB 2.0 ports quantity	0
Security algorithms	128-bit WEP, 256-bit WEP, 64-bit WEP, SSID, WPA, WPA2
Number of SSID supported	8
Operating temperature (T-T)	-20 - 70 °C
Storage relative humidity (H-H)	-30 - 80 %
Operating relative humidity (H-H)	0 - 90 %
AC input voltage	24 V
Power requirements	24V AC / 0.6A
Output power description	800 mW
Flash memory	8 MB
Internal memory	32 MB
Processor model	Qualcomm Atheros AR7240