EnGenius EOC5611P - Page 2

Learn more about EnGenius Solutions at www.engeniustech.com.sg
Datasheet
EOC5611P
BUSINESS CLASS
EOC5611P
EOC5611P Datasheet Version 03092010
*Theoretical wireless signal rate based on IEEE standard of 802.11 a, b, g, n chipset used. Actual throughput may vary.Network conditions and environmental
factors lower actual throughput rate.
** All specifications are subject to change without notice
FEATURES
Wireless
- 5GHz / 2.4GHz It works in 5GHz / 2.4GHz frequency spectrum
- High output power Transmit output power programmable for different country selections
- High Data Rate High speed transmitting rate up to 54Mbps, supports large payload such as video streaming
- Multifunction application Access Point/Client Bridge/Client Router/WDS AP/WDS CB
- Long range transmitting Transmit power control and distance control (ACK timeout)
- Signal Strength Display LED indicators have the best transmit and receive signal for traffic communication. And RF signal
strength status shown LEDs of 3 colors, making network build-up easier
- Narrow Bandwidth Provide 5MHz/10MHz/20MHz bandwidth selection.
- Multiple SSID 4 SSID supported. Each SSID can set itself wireless or WAN access setting.
- QoS(WMM) Enhance performance and density
Networking
- PPPoE Point-to-Point Protocol over Ethernet at Client Router mode. This function will keep trying when failed or disconnected
- PPTP Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
- VPN Pass Through
Security
- 802.11i WEP, WPA, WPA2 (Encryption support TKIP/AES)
- MAC address functions MAC address filter (AP mode)
- 802.1x IEEE802.1x Authenticator
- Station isolation L2 Isolation
Management
- Firmware Upgrade Upgrading firmware via web browser, setting are reserved after upgrade
- Reset & Backup Reset to factory default. User can export all setting into a file via WEB
- MIB MIB I, MIB II(RFC1213), Private MIB
- SNMP V1, V2c