19PRESENCEB
20DEPTHBOOST
21MEGALOPUNCH
22REVERB
Power amp Presence B knob. This knob determines the power amp's high frequency
response when is activated. The green LED next to the knob lights up to
indicate isactive.
The two Presence knobs afford you a host of interesting and worthwhile options for
shaping sounds: You can dial in different settings on the Presence A and B knobs (for
example,set to10o'clockand to3o'clock)andassignthesetwo
knobs to different preamp channels and sound modes ( & ) in various
MIDI presets. Note that simply switching from to while the
preamp setting remains the same yields different sonic results, not to mention all the
otheroptions.Again,Irecommendthatyouexploreandexperimentfreelytodiscover
theuntoldcombinationsandconfigurationsatyourfingertips.
Push the Depth Boost button to beef up the bottom end by about 6 dB. The red LED
above the button lights up to indicate the power amp Depth Boost feature is
activated. It can also be activated remotely via MIDI program change or Custom Z-9
Footswitch.
In contrast to the preamp feature (21), is wired into the
power amp circuitry (specifically in the feedback circuit). Though they both boost
bottom-end frequencies, these two functions have different effects. In combination
with the Presence A and B knobs, forms a separate power amp voicing
section that you can mix and match with different preamp channel settings and the
TubeDriver circuit,addingdifferenthuesto yoursonicpalette,andtweaking tonesto
suityourtaste.
Whenactivated, this function boosts low-end frequencies inallfourpreampchannels.
The redLED above the button lightsup to indicate this functionis on.
does not influence the Tube Driver circuit. It may also be activated remotely via MIDI
programchangeorCustomZ-9Footswitch.
effects vary, particularly in Lead channel Modern and Classic
operating modes. When is on, it boosts the bottom-end much in the way of
the power amp feature , meaning that it audibly increases sound
pressure.WhenClassicmodeisactivated, theeffectdependsonthe Gainknobsetting
andisnotnearlyaspronounced.AtveryhighGainsettingsanddependingonthetype
of pickup, the signal's low end may become rather muddy. When you configure the
amp in Classic mode and dial in a high gain level, I strongly suggest you deactivate
MegaLoPunch.
This button activates and deactivates the onboard spring reverb system. The red LED
above thebutton lights upto indicate is active.This button isimportant when
you're programming MIDI patches. Use it to assign the internal reverb signal to the
Presence B
PresenceB
PresenceA PresenceB
Modern Classic
Presence A Presence B
Mega Lo Punch Depth Boost
Depth Boost
Mega LoPunch
Mega Lo Punch's
Modern
Depth Boost
Reverb
Atipfromthedesigner:
Atipfromthedesigner:
Atipfromthedesigner:
11
To Next Page
Loading...
