Engl E670 - Effect Loop and Line Output Connections

59THRESHOLDLEVEL
Atipfromthedesigner:
60SERIALFXLOOPSEND
61SERIALFXLOOPRETURN
62FXLOOPISEND
63 FX LOOP I RETURN
64 BALANCE
NOTE:
Use this knob to seta thresholdvalue (thatis, the noise level) atwhich the
activatestosuppressthesignal.Thefurtheryoutwisttheknobtotheright,thehigher
the signal level at which the kicks in. The can be activated and
deactivatedas requiredfortheCrunchchannel andthetwoLeadchannels bypushing
thefrontpanelbutton(46).
, and generate different levels of noise, and I tuned the
ENGLSpecialEdition's accordingly.However,thereissomeminormatching
variance between the three. (Lead channel and activated) stands
tobenefitmostfromthe ,soIsuggestthatyoutweakitstwoknobsforthis
mode.
Connect this output to a signal processor's input/return jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the Serial FX Loop (24) button. In the signal path, the is located post
preampandprethetwomaineffectloops and .
Connect this Serial FX Loop input to a signal processor's output/send jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the Serial FX Loop (24) button. In the signal path, the is located post
preampandprethetwomaineffectloops and .
Connect this FX Loop I output to a signal processor's input/return jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the FX Loop I/II (23) button, which switches between these two loops. In the signal
path, is located post preamp, post and pre the two power
ampMasterknobs.
ConnectthisFXLoopIinputtoasignalprocessor'soutput/sendjackusingtheshortest
possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via the FX
Loop I/II (23) button, which switches between these two loops. In the signal path,
islocatedpostpreamp,post and prethetwo powerampMaster
knobs.
FX mix control for . When the knob is set to , the amp signal is routed
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patchedtothepoweramp(serial,100%wet).
Set this knob to when this loop is not in use!
Noise Gate
Noise Gate Noise Gate
Crunch Soft Lead Heavy Lead
NoiseGate
Heavy Lead Hi Gain
NoiseGate
Serial FX Loop
Serial FX Loop
FXLoopI FXLoopII
Serial FX Loop
FXLoopI FXLoopII
FX Loop I Serial FX Loop
FX
LoopI SerialFXLoop
FX Loop I Dry
Dry
24