Engl E670 - Page 25

65 FX LOOP II SEND
66 FX LOOP II RETURN
67 BALANCE
NOTE:
Atipfromthedesigner:
69OVERLOAD
Connect this FX Loop II output to a signal processor's input/return jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the FX Loop I/II (23) button, which switches between these two loops. In the signal
path, is located post preamp, post and pre the two power
ampMasterknobs.
Connect this FX Loop II input to a signal processor's output/send jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the FX Loop I/II (23) button, which switches between these two loops. In the signal
path, is located post preamp, post and pre the two power
ampMasterknobs.
FX mix control for . When the knob is set to , the amp signal is routed
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patchedtothepoweramp(serial,100%wet).
Setthisknobto whenthisloopisnotinuse!
This knob determines the level of the frequency-compensated Line Out (72). Use it to
adjust theamp's line output signal level to match the input gain ofthe mixing desk or
recorder'sinput.
ThefollowingfactorsdetermineLineOutlevel(72):
1. When button 70 is set to , input level (Gain), the given channels' Volume
knobs,andtosomeextent,thetonecontrolsandsound-shapingbuttons'settings.
2. When button 70 is set to , all the above as well as the activated Master,
Presenceknobs'settingsand
Thosearealotofvariables,soIrecommendyouproceedasfollows:Configurebuttons
as desired and dial in the desired settings on the front panel. Adjust the levels of
connectedFX devices andsignal processors. Finally,use theLevel controlto adjust the
line level. The Line Out is not overloaded until the Overload LED (69) lights up
continuously. You can push the level up to this point to match a mixer desk or
recorder's input level requirements. Use the given device's input sensitivity or gain
controltofine-tunethelinelevel.
This LED lights up totell youthe Line Out is saturated.If itilluminates, simply roll back
thesignallevelusingtheLevelknob(68).
FX Loop II Serial FX Loop
FX Loop II Serial FX Loop
FX Loop II Dry
Dry
Preamp
Poweramp
DepthBoost.
68 LEVEL
25