Technical Data
Output power:
Input sensitivity
Output level
Power consumption:
Fuses:
Important:
Tubes:
Logic control system:
System interfaces:
Dimensions:
Weight:
Input:
Effect Return:
SEND, level range:
Frequ.Comp. Line Out:
external:
at 230/240 mains voltage
at 100/115/120 mains voltage
internal:
V1, V2, V3, V4:
V5:
V6, V7:
V8, V9:
Consult Tube Map
to view tube array
Processor, software:
Memory:
MIDI:
Serial Amp Control:
42
approx. 100 watts in Hi Power mode,
approx. 50 watts in Lo Power mode adjusted
accordingly to 4, 8 and 16 ohms
approx. 390 watts max., equipped
(2 amps slo-blo)
(4 amps slo-blo)
2 x 2.5 ATL (2 amps slo-blo)
AT89C52 µC with internal 8K Flash Memory for
software source code; Upgradeable with
external Programmer;
EEPROM 93C66 for data retention;
Asynchronous data protocol according to the
MIDI standard;
Proprietary ENGL asynchronous data protocol
approx. (l x h x d);
approx.
adjusted accordingly to 4, 8 and 16 ohms;
6L6GC (factory loaded) or EL34, matched sets;
ECC83 F.Q., input tube;
Replace tubes with selected sets only!
MIDI program changes 0 - 127;
MIDI channels 1 - 16
MIDI controller 7 (main volume), value 0-5 =
Master Volume Mute,
Replace these with fuses of the same type and
rating only!
from -20 dB, nominal, max. 0 dB
from -20 dB nominal, max. 0 dB
from -20 dB to approx. 0 dB max.
+6 dB ;
with 6L6GC
power tubes;
2 ATL
4 ATL
.
max.
ECC83 selected;
ECC83 standard;
Mute, value > 5 = default
Master Volume level;
71 x 28 x 29 cm
26 kg
To Next Page
Loading...
