Fig.3
6. When the unit passes self test, the LCD Display will show (fig 2 A), its Automatic Default –
20 kilograms. The ADS 2000 has just passed the self-test.
7. If you get readout 2 B. “SWITCH TO SET", then place the SET / RUN switch to "SET". The
display will now give readout "A" or "C", if you get readout "A." then proceed to Step 6.
8. If you get readout 2 C. “SWITCH MASK OFF" then place the "MASK" switch to "O" or
"OFF". The display will now give readout "A", proceed to Step 6.
9. If you get any one of the error messages "D" through "H" please refer to
TROUBLESHOOTING THE ADS 2000, section of this manual, beginning on page 24.
10. If a message as in figure 3 is displayed, a hose from the Breathing Circuit or the Gas
Sampling Circuit is not connected properly. Re-connect hoses and try again.
The ADS 2000 is ready for operation!
Note: Do not connect TEST LUNG / patient until unit has passed self-test.
SET MODE
In this section you will learn and set up the parameters of the ADS 2000 in the "SET
MODE". The "SET MODE" is the resting or static mode for the ADS 2000. The "SET
MODE" is the mode in which you will enter the patients' weight in kilograms and from
that input the ADS 2000 will select all of the other parameters for you. Of course, the
ADS 2000 will only select values based on an average, if at any time you wish to
change any parameter, you may do so at any time.
THE LCD DISPLAY in SET MODE. Figure 2 A shows the default 20 kilograms display
once the self test process is completed.
1. Make sure that the SET / RUN switch is in the "SET MODE".
2. As shown on figure 2A we can see the following:
a. Patient default Weight is pre-selected at 20 Kilograms.
b. The default Flow Rate is pre-selected to a value of 24 liters per minute.
12 Engler Engineering Corporation ADS 2000
To Next Page
Loading...