Software Release: [App: 02.09.10051.00; Config: 2.9.20024; Built in PowerVision Configuration Studio Version: 2.9.23042;
BTL: 02.09.10015.00]
Section 40 52 00-02-0939
2019-06-13
J1939.Actual Engine Torque
J1939.Diesel Particulate Filter Outlet Temperature
J1939.Diesel Particulate Filter Intake Temperature
J1939.Exhaust Temperature
J1939.Engine Exhaust Manifold Bank 1 Temperature
J1939.Engine Fuel Temperature
J1939.Engine Intercooler Temperature
J1939.Diesel Particulate Filter Ash Load Percent
J1939.Diesel Exhaust Fluid Tank Temperature
J1939.Engine Fuel Delivery Pressure
J1939.Barometric Pressure
J1939.Air Filter Diff. Pressure
J1939.Exhaust Gas Temperature
J1939.Hydraulic Temperature
J1939.Diesel Particulate Filter Active Regeneration Status: The
following is a description of enumeration values.
System Level Engine Start (Auto) (50.5ft will read 505)
System Level Engine Stop (Auto) (50.5ft will read 505)
System Level Maintain Value (Auto) (50.5ft will read 505)
Actual Discharge Pressure
Pressure Engine Start (Auto)
Pressure Engine Stop (Auto)
Pressure Maintain Value (Auto)
J1939.Engine Catalyst Tank Level
J1939.Diesel Particulate Filter 1 Soot Load Percent
J1939.Diesel Particulate Filter Regeneration Inhibit Switch (Inhibit
Switch Active = 1)
The following is a description of bits:
0 = J1939.Diesel Particulate Filter Active Regeneration
Inhibited Due to Inhibit Switch (Inhibited = 1)
To Next Page
Loading...
Need help?
General
