© 2019 Enphase Energy Inc.
o Copper conductors for push terminals: 2.5mm
2
to 4mm
2
(11mm strip length) rated at
75° C or 90° C.
o Gland or strain relief fitting: one for each used conduit opening in the AC junction box.
o OCPD: 20A maximum over current protection and readily accessible disconnecting
means in accordance with local standards.
o Personal protective equipment (PPE) for handling lithium ion batteries as required by
local safety standards.
c. Ensure that you have the following optional items, if needed:
• 20A maximum AC isolator
• Conduit and fittings
• Stud finder
d. Install the PV system and the Envoy-S as directed by the installation manuals.
e. To record the location(s) of the AC Battery(ies), peel the removable serial number label from each
battery and affix it to the respective location on a paper installation map. You will scan this map later
using the Enphase Installer Toolkit™ and your mobile device.
To Next Page
Loading...
Need help?
General